All

Ghost Wire 2.0, Super Flat Adhesive Speaker Wire

Make speaker wires disappear right on the wall or under the carpet with Sewell Adhesive Speaker Wire.

This super-flat speaker wire can be used on almost any flat surface. Perfect for running stereo signals across rooms, around corners, in automobiles, under flooring, or any situation where wires cannot be run through walls.

White backing allows wires to be simply attached and left uncovered, or it can be easily covered with paint, spackle, or flooring making the wire virtually invisible.

Inspired Wires

Although it sounds spooky, Ghost Wire by Sewell probably won’t land you a new reality show or a made-for-TV movie. The benefits will outlast your 15 minutes of fame, though. For many people, the idea of running traditional speaker wire through walls or molding is chilling. It can be a huge, complex job fraught with uncertainties and questionable aesthetics. How do you get through studs? What size wire molding do you need? What happens if you change your mind and rearrange your room?

That’s the Spirit

The only thing scary about Ghost Wire is how flat and invisible it can be. With a strong adhesive on one side, this speaker wire can be run along walls, floors, and under carpets. The wire itself is only .5mm thick so it can be easily camouflaged with paint or wallpaper on visible surfaces. Want a truly hidden seam? A thin layer of spackle along the edges makes the wire truly undetectable. You don’t even have to sacrifice quality for convenience. Ghost Wire is made from 100% pure solid copper so you can expect the same clear, clean audio as you would from any of FireFold’s ordinary speaker wire.

This SW-29982 Ghost Wire Terminal Block is used to connect your flat wire to regular round speaker wire for terminations. Attaching the terminal block to the speaker wire is a breeze and requires only two ordinary household tools: a pair of scissors and a screwdriver. Simply peel the backing and adhesive sides off of the Ghost Wire until about an inch of bare copper is exposed. Cut off the excess paper then fold the copper in half twice. Insert the flat wire into one side of the terminal block and tighten the screws. Strip and insert 14, 16, or 18 AWG round speaker wire into the other side of the block and tighten those screws as well. Then, just hook up your speakers or receiver as you ordinarily would.

If you are looking for high quality secure connections, banana plugs are the way to go. Easy to install and made from high quality materials, these banana plugs are durable and well made. You will get the best connection possible with these simple to use screw type dual banana plugs. Simply unscrew the two small screws inside the plug, feed your speaker wire through the hole in the bottom or the side, and tighten the screws onto the wire. And you're done!